Hallo zusammen,
ich habe gerade ein neues System mit einem ASRock H87M-ITX aufgebaut - bekomme aber leider "Wake on LAN" nicht zum fliegen.
"Power on PCI/PCIE Devices" habe ich im UEFI Setup aktiviert.
Ethernet Adapter ist der folgende:
lspci | grep -i net 02:00.0 Ethernet controller: Qualcomm Atheros QCA8171 Gigabit Ethernet (rev 10)
Wake on LAN Fähigkeit wird gar nicht angezeigt:
sudo ethtool eth0 Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: internal Auto-negotiation: on MDI-X: Unknown Current message level: 0x000060e4 (24804) link ifup rx_err tx_err hw wol Link detected: yes
sudo ethtool -s eth0 wol g Cannot get current wake-on-lan settings: Operation not supported not setting wol
cat /proc/acpi/wakeup Device S-state Status Sysfs node USB1 S3 *disabled RP01 S4 *disabled pci:0000:00:1c.0 RP03 S4 *disabled pci:0000:00:1c.2 GLAN S4 *disabled EHC1 S4 *enabled pci:0000:00:1d.0 EHC2 S4 *enabled pci:0000:00:1a.0 XHC S4 *enabled pci:0000:00:14.0 HDEF S4 *disabled pci:0000:00:1b.0 PEG0 S4 *disabled PEGP S4 *disabled PEG1 S4 *disabled PEG2 S4 *disabled
Hat jemand 'ne Idee was ich da machen kann?
Danke schonmal!