Hallo Freunde,
das ist mein 1. Eintrag. Meine ipw2200 will einfach nicht. Habe einen Amilo 7400D Laptop, wo wireless bei Windows XP funktionierte. Habe im BIOS die Card enabled.
Trotzdem meldet mir die dmesg:
[ 23.696000] ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection [ 23.964000] ipw2200: [b]Radio Frequency Kill Switch is On:[/b] [ 23.964000] [b]Kill switch must be turned off for wireless networking to work.[/b] [ 23.964000] ipw2200: Detected geography ZZM (11 802.11bg channels, 0 802.11a channels)
noch die lspci:
02:06.0 Network controller: Intel Corporation PRO/Wireless 2200BG Network Connection (rev 05)
also erkannt.
noch iwconfig:
xxx@xxx-laptop:~$ iwconfig lo no wireless extensions. eth0 no wireless extensions. eth1 radio off ESSID:"[i]da steht das SSID Wort drin[/i]" Mode:Managed Channel:0 Access Point: Not-Associated Bit Rate:0 kb/s Tx-Power=off Sensitivity=8/0 Retry limit:7 RTS thr:off Fragment thr:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Schnittstelle eth1 schon erkannt, aber eben radio off.
Wo ist denn dieser besagte Radio Frequency Kill Switch? Doch nicht der Funk an/aus Knopf auf dem Laptop, der hat unter Linux keine Funktion. Oder an welcher config muss man rumschrauben? Habe schon stundenlang rumgemurkst. Um das Funknetzwerk ans Laufen zu bringen muss ich wohl diesen "Schalter" finden.
Zusatz: Habe auf die Seite http://ipw2200.sourceforge.net/README.ipw2200 geschaut und folgendes entdeckt:
1.4.2 Device Level Sysfs Helper Files ----------------------------------------------- For the device level files, look in /sys/bus/pci/drivers/ipw2200/{PCI-ID}/ For example: /sys/bus/pci/drivers/ipw2200/0000:02:01.0 For the device level files, see /sys/bus/pci/drivers/ipw2200: rf_kill read - 0 = RF kill not enabled (radio on) 1 = SW based RF kill active (radio off) 2 = HW based RF kill active (radio off) 3 = Both HW and SW RF kill active (radio off) write - 0 = If SW based RF kill active, turn the radio back on 1 = If radio is on, activate SW based RF kill NOTE: If you enable the SW based RF kill and then toggle the HW based RF kill from ON -> OFF -> ON, the radio will NOT come back on
Mein rf_kill Status ist:
xxx@xxx-laptop:/sys/bus/pci/drivers/ipw2200/0000:02:06.0$ cat rf_kill 2
also Hardware based RF kill.
Wie bewerkstellige ich es, dass der Wert 0 wird? Gibts wo ein config-File?
Vielen Dank für eine Antwort