toll ... nun ein zweites mal, nachdem ich schon fast den gesamten Text geschrieben habe und auf "Hilfe zum Syntax" gedrückt
habe, den Link sollte man mal lieber in einem neuen Fenster starten lassen, weil das Dokument, welches ich angelegt habe ja nun expired war 😕 soviel offtopic...
Also ..... ich habe es mit
sudo setcap 'cap_sys_tty_config+ep' /usr/bin/directvnc
probiert, musste dann leider aber trotzdem mit Sudo den directvnc starten in der Gruppe video bin ich,
sudo directvnc localhost:1 -m de
startet den VNC mit einer Fehlermeldung wegen -m de (aber ohne gehts irgendwie nicht),
das Passwort für den VNC-Server eingeben und dann habe ich ein Bild was ungefähr so aussieht:
http://250kb.de/u/160511/j/bWf9cIrLCOQZ.jpg
das Fenster ist irgendwie zweigeteilt in der Mitte und man kommt nicht
an die Menüleiste im unteren Bereich....
hier meine Rapi-Boot, vielleicht muss ich da noch was hinzufügen,
ich weiß leider nicht was ???
# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details
# uncomment if you get no picture on HDMI for a default "safe" mode
hdmi_safe=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
overscan_left=-16
overscan_right=-16
overscan_top=-16
overscan_bottom=-16
# uncomment to force a console size. By default it will be display's size minus
# overscan.
framebuffer_width=800
framebuffer_height=600
#framebuffer_width=1024
#framebuffer_height=768
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=1
hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
#uncomment to overclock the arm. 700 MHz is the default.
arm_freq=1000
# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on
# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi
# Additional overlays and parameters are documented /boot/overlays/README
# Enable audio (loads snd_bcm2835)
dtparam=audio=on
ich hoffe das mir da noch jemand helfen kann ??? ...