@Kellerkind, danke dir...
lspci -nnk | grep -i net -A2
00:19.0 Ethernet controller [0200]: Intel Corporation Ethernet Connection (3) I218-LM [8086:15a2] (rev 03)
Subsystem: Lenovo Ethernet Connection (3) I218-LM [17aa:2226]
Kernel driver in use: e1000e
Kernel modules: e1000e
--
03:00.0 Network controller [0280]: Intel Corporation Wireless 7265 [8086:095b] (rev 59)
Subsystem: Intel Corporation Dual Band Wireless-AC 7265 [8086:5210]
Kernel driver in use: iwlwifi
cat /etc/modprobe.d/blacklist.conf
# This file lists those modules which we don't want to be loaded by
# alias expansion, usually so some other driver will be loaded for the
# device instead.
# evbug is a debug tool that should be loaded explicitly
blacklist evbug
# these drivers are very simple, the HID drivers are usually preferred
blacklist usbmouse
blacklist usbkbd
# replaced by e100
blacklist eepro100
# replaced by tulip
blacklist de4x5
# causes no end of confusion by creating unexpected network interfaces
blacklist eth1394
# snd_intel8x0m can interfere with snd_intel8x0, doesn't seem to support much
# hardware on its own (Ubuntu bug #2011, #6810)
blacklist snd_intel8x0m
# Conflicts with dvb driver (which is better for handling this device)
blacklist snd_aw2
# causes failure to suspend on HP compaq nc6000 (Ubuntu: #10306)
blacklist i2c_i801
# replaced by p54pci
blacklist prism54
# replaced by b43 and ssb.
blacklist bcm43xx
# most apps now use garmin usb driver directly (Ubuntu: #114565)
blacklist garmin_gps
# replaced by asus-laptop (Ubuntu: #184721)
blacklist asus_acpi
# low-quality, just noise when being used for sound playback, causes
# hangs at desktop session start (Ubuntu: #246969)
blacklist snd_pcsp
# ugly and loud noise, getting on everyone's nerves; this should be done by a
# nice pulseaudio bing (Ubuntu: #77010)
blacklist pcspkr
# EDAC driver for amd76x clashes with the agp driver preventing the aperture
# from being initialised (Ubuntu: #297750). Blacklist so that the driver
# continues to build and is installable for the few cases where its
# really needed.
blacklist amd76x_edac
#blacklist Edimax Wlan USB Stick
blacklist rtl_usb
blacklist rtl8192c_common
blacklist rtl8192cu
dmesg | egrep 'net|eth|sky|sun|sis|via|3c3|3c5|e100|8139|8169|acx|air|ath|atl|ar9|carl|atme|at7|herm|iwl|ipw|rtl8|r81|rt2|rt3|rt6|rt7|tg3|ssb|wl|b43|b44|ori|pri|p5|zd|ndis|wmi|ns8|FW'
[ 0.000000] Command line: BOOT_IMAGE=/boot/vmlinuz-4.4.0-34-generic root=UUID=4932e9e1-8ee5-4bf2-8f34-ad66b441c325 ro quiet splash vt.handoff=7
[ 0.000000] PERCPU: Embedded 33 pages/cpu @ffff88022dc00000 s98008 r8192 d28968 u262144
[ 0.000000] pcpu-alloc: s98008 r8192 d28968 u262144 alloc=1*2097152
[ 0.000000] Kernel command line: BOOT_IMAGE=/boot/vmlinuz-4.4.0-34-generic root=UUID=4932e9e1-8ee5-4bf2-8f34-ad66b441c325 ro quiet splash vt.handoff=7
[ 0.000000] Calgary: detecting Calgary via BIOS EBDA area
[ 0.021037] Initializing cgroup subsys net_cls
[ 0.021041] Initializing cgroup subsys net_prio
[ 0.022039] CPU0: Thermal monitoring enabled (TM1)
[ 0.038139] ..TIMER: vector=0x30 apic1=0 pin1=2 apic2=-1 pin2=-1
[ 0.709224] audit: initializing netlink subsys (disabled)
[ 0.713936] thermal LNXTHERM:00: registered as thermal_zone0
[ 0.713937] ACPI: Thermal Zone [THM0] (67 C)
[ 0.790357] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
[ 0.813516] microcode: Microcode Update Driver: v2.01 <tigran@aivazian.fsnet.co.uk>, Peter Oruba
[ 0.813922] Loading compiled-in X.509 certificates
[ 1.010174] wmi: Mapper loaded
[ 1.019911] e1000e: Intel(R) PRO/1000 Network Driver - 3.2.6-k
[ 1.019913] e1000e: Copyright(c) 1999 - 2015 Intel Corporation.
[ 1.020046] e1000e 0000:00:19.0: Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
[ 1.302796] e1000e 0000:00:19.0 eth0: registered PHC clock
[ 1.302808] e1000e 0000:00:19.0 eth0: (PCI Express:2.5GT/s:Width x1) 68:f7:28:de:67:b8
[ 1.302810] e1000e 0000:00:19.0 eth0: Intel(R) PRO/1000 Network Connection
[ 1.302835] e1000e 0000:00:19.0 eth0: MAC: 11, PHY: 12, PBA No: 1000FF-0FF
[ 1.303302] e1000e 0000:00:19.0 enp0s25: renamed from eth0
[ 1.598695] fbcon: inteldrmfb (fb0) is primary device
[ 3.942625] raid6: using algorithm avx2x4 gen() 25816 MB/s
[ 3.942626] raid6: using avx2x2 recovery algorithm
[ 4.197025] systemd[1]: Starting Monitoring of LVM2 mirrors, snapshots etc. using dmeventd or progress polling...
[ 4.394227] thinkpad_acpi: http://ibm-acpi.sf.net/
[ 4.446165] iwlwifi 0000:03:00.0: Direct firmware load for iwlwifi-7265D-19.ucode failed with error -2
[ 4.446180] iwlwifi 0000:03:00.0: Direct firmware load for iwlwifi-7265D-18.ucode failed with error -2
[ 4.446191] iwlwifi 0000:03:00.0: Direct firmware load for iwlwifi-7265D-17.ucode failed with error -2
[ 4.450739] iwlwifi 0000:03:00.0: loaded firmware version 16.242414.0 op_mode iwlmvm
[ 4.476922] iwlwifi 0000:03:00.0: Detected Intel(R) Dual Band Wireless AC 7265, REV=0x210
[ 4.477274] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 4.478484] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 4.551579] Adding 14648316k swap on /dev/sda2. Priority:-1 extents:1 across:14648316k SSFS
[ 4.566901] ieee80211 phy0: Selected rate control algorithm 'iwl-mvm-rs'
[ 4.604249] iwlwifi 0000:03:00.0 wlp3s0: renamed from wlan0
[ 4.960602] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 5.439951] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 5.440335] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 5.440790] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 5.504237] usb 2-1: rtl8xxxu: Loading firmware rtlwifi/rtl8192cufw_TMSC.bin
[ 5.508925] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 5.509383] iwlwifi 0000:03:00.0: L1 Enabled - LTR Enabled
[ 5.532961] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 5.649963] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 5.916743] usbcore: registered new interface driver rtl8xxxu
[ 5.920104] rtl8xxxu 2-1:1.0 wlx801f02b34f30: renamed from wlan0
[ 5.946235] IPv6: ADDRCONF(NETDEV_UP): wlx801f02b34f30: link is not ready
[ 5.950312] IPv6: ADDRCONF(NETDEV_UP): wlx801f02b34f30: link is not ready
[ 5.993140] IPv6: ADDRCONF(NETDEV_UP): wlx801f02b34f30: link is not ready
[ 9.020123] wlp3s0: authenticate with c4:04:15:6b:2b:18
[ 9.026498] wlp3s0: send auth to c4:04:15:6b:2b:18 (try 1/3)
[ 9.042757] wlp3s0: authenticated
[ 9.046834] wlp3s0: associate with c4:04:15:6b:2b:18 (try 1/3)
[ 9.059522] wlp3s0: RX AssocResp from c4:04:15:6b:2b:18 (capab=0x431 status=0 aid=2)
[ 9.084076] wlp3s0: associated
[ 9.084104] IPv6: ADDRCONF(NETDEV_CHANGE): wlp3s0: link becomes ready
[ 9.896598] IPv6: wlp3s0: IPv6 duplicate address fe80::fd3e:a69e:ebcd:474 detected!
[ 10.017334] IPv6: wlp3s0: IPv6 duplicate address fe80::3604:5982:58d4:742e detected!
[ 10.404362] IPv6: wlp3s0: IPv6 duplicate address fe80::d6d4:cc70:f1f5:9e94 detected!
[ 11.165141] /dev/vmnet: open called by PID 1448 (vmnet-bridge)
[ 11.165147] /dev/vmnet: hub 0 does not exist, allocating memory.
[ 11.165166] /dev/vmnet: port on hub 0 successfully opened
[ 11.165172] bridge-wlp3s0: device is wireless, enabling SMAC
[ 11.165173] bridge-wlp3s0: up
[ 11.165177] bridge-wlp3s0: attached
[ 12.173127] /dev/vmnet: open called by PID 1503 (vmnet-netifup)
[ 12.173137] /dev/vmnet: hub 1 does not exist, allocating memory.
[ 12.173149] /dev/vmnet: port on hub 1 successfully opened
[ 12.190637] /dev/vmnet: open called by PID 1507 (vmnet-dhcpd)
[ 12.190649] /dev/vmnet: port on hub 1 successfully opened
[ 12.196863] /dev/vmnet: open called by PID 1520 (vmnet-natd)
[ 12.196869] /dev/vmnet: hub 8 does not exist, allocating memory.
[ 12.196878] /dev/vmnet: port on hub 8 successfully opened
[ 12.198843] /dev/vmnet: open called by PID 1521 (vmnet-netifup)
[ 12.198851] /dev/vmnet: port on hub 8 successfully opened
[ 12.213915] /dev/vmnet: open called by PID 1528 (vmnet-dhcpd)
[ 12.213924] /dev/vmnet: port on hub 8 successfully opened