Hallo nochmal, das problem hat sich durch nichts-tun leider nicht gelöst, schade aber auch!
Ich hab die Platte jetzt gerade mal in den X200 von nem Kumpel eingelegt und dieselben Befehle wie oben durchgeführt:
smartctl 6.5 2016-01-24 r4214 [x86_64-linux-4.4.0-47-generic] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: ST250LT002-9VM14C
Serial Number: W0Q0K924
LU WWN Device Id: 5 000c50 038e1a7c6
Firmware Version: 0004LVM7
User Capacity: 250.059.350.016 bytes [250 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7242 rpm
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Wed Dec 28 22:35:27 2016 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 62) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 099 034 Pre-fail Always - 151832069
3 Spin_Up_Time 0x0003 098 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 096 096 020 Old_age Always - 4809
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 068 060 030 Pre-fail Always - 137663984733
9 Power_On_Hours 0x0032 089 089 000 Old_age Always - 10152 (173 222 0)
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 096 096 020 Old_age Always - 4563
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
188 Command_Timeout 0x0032 100 060 000 Old_age Always - 154621183736
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 073 048 045 Old_age Always - 27 (Min/Max 24/27)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 249
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 51
193 Load_Cycle_Count 0x0032 012 012 000 Old_age Always - 176935
194 Temperature_Celsius 0x0022 027 052 000 Old_age Always - 27 (0 5 0 0 0)
195 Hardware_ECC_Recovered 0x001a 060 051 000 Old_age Always - 151832069
196 Reallocated_Event_Count 0x000f 089 089 030 Pre-fail Always - 9783 (14172 0)
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 151 000 Old_age Always - 2870
254 Free_Fall_Sensor 0x0032 001 001 000 Old_age Always - 17
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 10152 -
# 2 Short offline Completed without error 00% 10137 -
# 3 Short offline Completed without error 00% 9810 -
# 4 Short offline Completed without error 00% 9803 -
# 5 Short offline Completed without error 00% 9696 -
# 6 Extended offline Aborted by host 90% 9695 -
# 7 Extended offline Completed without error 00% 9391 -
# 8 Short offline Completed without error 00% 9390 -
# 9 Vendor (0x50) Completed without error 00% 0 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
Ich denke die Interessanten Zeilen sind:
188 Command_Timeout 0x0032 100 060 000 Old_age Always - 154621183736
199 UDMA_CRC_Error_Count 0x003e 200 151 000 Old_age Always - 2870
Älterer Laptop der super mit eigener Festplatte läuft und eine kleine Verschlimmerung der Werte wenn ich meine Einlege. Liege ich jetzt richtig in der Annahme, dass das Problem sich auf die Festplatte reduzieren lässt und nicht auf die Hardware? Einen neue Festplatte müsste das ganze also lösen oder?