Wieso greift das mii-tool auf eth0 bis eth7 zu ?
1 2 3 4 5 6 7 8 9 10 | mii-tool SIOCGMIIPHY on 'eth0' failed: Operation not permitted SIOCGMIIPHY on 'eth1' failed: Operation not permitted SIOCGMIIPHY on 'eth2' failed: Operation not permitted SIOCGMIIPHY on 'eth3' failed: Operation not permitted SIOCGMIIPHY on 'eth4' failed: Operation not permitted SIOCGMIIPHY on 'eth5' failed: Operation not permitted SIOCGMIIPHY on 'eth6' failed: Operation not permitted SIOCGMIIPHY on 'eth7' failed: Operation not permitted no MII interfaces found |
Müsste nicht viel mehr hier stehen?
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 | cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: load balancing (round-robin) MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: enp9s0f1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:17:bf:f6:e1 Slave queue ID: 0 |