Ja, das ist eine Fehlerquelle. Konkret handelt es sich um DNS-Anfragen, die in UDP-Paketen transportiert werden.
Installiere bitte das Paket ethtool!
Zeige die aktuellen Einstellungen der Ethernet-Schnittstellen-Hardware:
sudo ethtool --show-features enp0s25und die Art der PCI-Karte:
lspci -s 00:19 -nnk
$ sudo ethtool --show-features enp0s25 Features for enp0s25: rx-checksumming: on tx-checksumming: on tx-checksum-ipv4: off [fixed] tx-checksum-ip-generic: on tx-checksum-ipv6: off [fixed] tx-checksum-fcoe-crc: off [fixed] tx-checksum-sctp: off [fixed] scatter-gather: on tx-scatter-gather: on tx-scatter-gather-fraglist: off [fixed] tcp-segmentation-offload: off tx-tcp-segmentation: off [requested on] tx-tcp-ecn-segmentation: off [fixed] tx-tcp-mangleid-segmentation: off tx-tcp6-segmentation: off [requested on] udp-fragmentation-offload: off generic-segmentation-offload: on generic-receive-offload: on large-receive-offload: off [fixed] rx-vlan-offload: on tx-vlan-offload: on ntuple-filters: off [fixed] receive-hashing: on highdma: on [fixed] rx-vlan-filter: off [fixed] vlan-challenged: off [fixed] tx-lockless: off [fixed] netns-local: off [fixed] tx-gso-robust: off [fixed] tx-fcoe-segmentation: off [fixed] tx-gre-segmentation: off [fixed] tx-gre-csum-segmentation: off [fixed] tx-ipxip4-segmentation: off [fixed] tx-ipxip6-segmentation: off [fixed] tx-udp_tnl-segmentation: off [fixed] tx-udp_tnl-csum-segmentation: off [fixed] tx-gso-partial: off [fixed] tx-sctp-segmentation: off [fixed] tx-esp-segmentation: off [fixed] fcoe-mtu: off [fixed] tx-nocache-copy: off loopback: off [fixed] rx-fcs: off rx-all: off tx-vlan-stag-hw-insert: off [fixed] rx-vlan-stag-hw-parse: off [fixed] rx-vlan-stag-filter: off [fixed] l2-fwd-offload: off [fixed] hw-tc-offload: off [fixed] esp-hw-offload: off [fixed] esp-tx-csum-hw-offload: off [fixed] rx-udp_tunnel-port-offload: off [fixed] $ lspci -s 00:19 -nnk 00:19.0 Ethernet controller [0200]: Intel Corporation 82562V-2 10/100 Network Connection [8086:10c0] (rev 02) Subsystem: Dell 82562V-2 10/100 Network Connection [1028:0238] Kernel driver in use: e1000e Kernel modules: e1000e
Möglicherweise hilft es, die Prüfsummenbildung in der Hardware abzuschalten.
Aha, das klingt interessant. Dieser Prüfsummenfehler tritt nämlich teilweise auch bei "Normalbetrieb" auf, wenn gerade kein DNS-Ausfall besteht, allerdings kommt dann abwechselnd [bad udp cksum 0x85a2 -> 0x2dfe!]
und [udp sum ok]
, wie ich bereits erwähnte.
Allerdings tritt der Fehler auch bei einem anderen x86-PC auf, welcher einen Atheros-Netzwerkchip hat.
Gruß