Das ist bei meinem Computer eine seeehr lange Ausgabe. Ich hab die mal für Dich gekürzt. Ich denke mal, Du möchtest da alles zur TV-Karte lesen. Dann wäre das für dmesg dieser Abschnitt:
[ 38.252510] scsi host7: vhba
[ 41.052050] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[ 41.106236] media: Linux media interface: v0.10
[ 41.113578] Linux video capture interface: v2.00
[ 41.141071] cx23885: cx23885 driver version 0.0.4 loaded
[ 41.141234] cx23885: CORE cx23885[0]: subsystem: 0070:f038, board: Hauppauge WinTV-HVR5525 [card=52,autodetected]
[ 41.483805] tveeprom: Hauppauge model 150329, rev C1I6, serial# 4035678402
[ 41.483807] tveeprom: MAC address is 00:0d:fe:8b:90:c2
[ 41.483808] tveeprom: tuner model is SiLabs Si2157 (idx 186, type 4)
[ 41.483810] tveeprom: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xf4)
[ 41.483810] tveeprom: audio processor is CX23888 (idx 40)
[ 41.483811] tveeprom: decoder processor is CX23888 (idx 34)
[ 41.483811] tveeprom: has radio, has IR receiver, has no IR transmitter
[ 41.483812] cx23885: cx23885[0]: hauppauge eeprom: model=150329
[ 41.483814] cx23885: cx23885_dvb_register() allocating 1 frontend(s)
[ 41.483815] cx23885: cx23885[0]: cx23885 based dvb card
[ 41.487231] i2c i2c-2: Added multiplexed i2c bus 5
[ 41.589601] nvidia-uvm: Loaded the UVM driver, major device number 236.
[ 41.594118] a8293 2-000b: Allegro A8293 SEC successfully attached
[ 41.612655] snd_hda_intel 0000:01:00.1: Disabling MSI
[ 41.612665] snd_hda_intel 0000:01:00.1: Handle vga_switcheroo audio client
[ 41.702255] m88rs6000t 5-0021: chip_id=64
[ 41.760253] usbcore: registered new interface driver usbserial_generic
[ 41.760262] usbserial: USB Serial support registered for generic
[ 41.770715] m88rs6000t 5-0021: Montage M88RS6000 internal tuner successfully identified
[ 41.770743] dvbdev: DVB: registering new adapter (cx23885[0])
[ 41.770746] cx23885 0000:05:00.0: DVB: registering adapter 0 frontend 0 (Montage Technology M88RS6000)...
[ 41.771157] cx23885: cx23885_dvb_register() allocating 1 frontend(s)
[ 41.771158] cx23885: cx23885[0]: cx23885 based dvb card
[ 41.782972] snd_hda_codec_realtek hdaudioC0D3: autoconfig for ALC889A: line_outs=4 (0x14/0x15/0x16/0x17/0x0) type:line
[ 41.782975] snd_hda_codec_realtek hdaudioC0D3: speaker_outs=0 (0x0/0x0/0x0/0x0/0x0)
[ 41.782976] snd_hda_codec_realtek hdaudioC0D3: hp_outs=1 (0x1b/0x0/0x0/0x0/0x0)
[ 41.782977] snd_hda_codec_realtek hdaudioC0D3: mono: mono_out=0x0
[ 41.782985] snd_hda_codec_realtek hdaudioC0D3: dig-out=0x1e/0x0
[ 41.782986] snd_hda_codec_realtek hdaudioC0D3: inputs:
[ 41.782987] snd_hda_codec_realtek hdaudioC0D3: Rear Mic=0x18
[ 41.782988] snd_hda_codec_realtek hdaudioC0D3: Front Mic=0x19
[ 41.782989] snd_hda_codec_realtek hdaudioC0D3: Line=0x1a
[ 41.782990] snd_hda_codec_realtek hdaudioC0D3: CD=0x1c
[ 41.782991] snd_hda_codec_realtek hdaudioC0D3: dig-in=0x1f
[ 41.800266] input: HDA ATI SB Rear Mic as /devices/pci0000:00/0000:00:14.2/sound/card0/input16
[ 41.800335] input: HDA ATI SB Front Mic as /devices/pci0000:00/0000:00:14.2/sound/card0/input17
[ 41.800374] input: HDA ATI SB Line as /devices/pci0000:00/0000:00:14.2/sound/card0/input18
[ 41.800412] input: HDA ATI SB Line Out Front as /devices/pci0000:00/0000:00:14.2/sound/card0/input19
[ 41.800450] input: HDA ATI SB Line Out Surround as /devices/pci0000:00/0000:00:14.2/sound/card0/input20
[ 41.800490] input: HDA ATI SB Line Out CLFE as /devices/pci0000:00/0000:00:14.2/sound/card0/input21
[ 41.800527] input: HDA ATI SB Line Out Side as /devices/pci0000:00/0000:00:14.2/sound/card0/input22
[ 42.040980] usbcore: registered new interface driver ti_usb_3410_5052
[ 42.040991] usbserial: USB Serial support registered for TI USB 3410 1 port adapter
[ 42.040996] usbserial: USB Serial support registered for TI USB 5052 2 port adapter
[ 42.041020] ti_usb_3410_5052 7-1.4.4:1.0: TI USB 3410 1 port adapter converter detected
[ 42.050556] usb 7-1.4.4: Direct firmware load for ti_usb-v0451-p3410.fw failed with error -2
[ 42.081215] i2c i2c-2: Added multiplexed i2c bus 6
[ 42.081217] si2168 2-0064: Silicon Labs Si2168-B40 successfully identified
[ 42.081218] si2168 2-0064: firmware version: B 4.0.2
[ 42.084120] si2157 3-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached
[ 42.084130] dvbdev: DVB: registering new adapter (cx23885[0])
[ 42.084133] cx23885 0000:05:00.0: DVB: registering adapter 1 frontend 0 (Silicon Labs Si2168)...
[ 42.084427] cx23885: cx23885_dev_checkrevision() Hardware revision = 0xd0
[ 42.084431] cx23885: cx23885[0]/0: found at 0000:05:00.0, rev: 4, irq: 17, latency: 0, mmio: 0xfd200000
[ 42.090140] usb 2-2: Warning! Unlikely big volume range (=1008), cval->res is probably wrong.
[ 42.090143] usb 2-2: [49] FU [PCM Playback Volume] ch = 2, val = -16129/-1/16
[ 42.126124] usb 2-2: Warning! Unlikely big volume range (=496), cval->res is probably wrong.
[ 42.126128] usb 2-2: [50] FU [Mic Capture Volume] ch = 1, val = 0/7936/16
[ 42.282394] input: HDA NVidia HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:02.0/0000:01:00.1/sound/card1/input23
[ 42.282443] input: HDA NVidia HDMI/DP,pcm=7 as /devices/pci0000:00/0000:00:02.0/0000:01:00.1/sound/card1/input24
[ 42.344462] usbcore: registered new interface driver snd-usb-audio
[ 42.393379] input: PC Speaker as /devices/platform/pcspkr/input/input25
[ 42.465323] kvm: Nested Virtualization enabled
[ 42.465327] kvm: Nested Paging enabled
[ 42.467127] MCE: In-kernel MCE decoding enabled.
[ 42.468865] EDAC amd64: Node 0: DRAM ECC disabled.
[ 42.468867] EDAC amd64: ECC disabled in the BIOS or no ECC capability, module will not load.
Either enable ECC checking or force module loading by setting 'ecc_enable_override'.
(Note that use of the override may cause unknown side effects.)
[ 42.512671] EDAC amd64: Node 0: DRAM ECC disabled.
[ 42.512674] EDAC amd64: ECC disabled in the BIOS or no ECC capability, module will not load.
Either enable ECC checking or force module loading by setting 'ecc_enable_override'.
(Note that use of the override may cause unknown side effects.)
[ 42.555265] EDAC amd64: Node 0: DRAM ECC disabled.
[ 42.555267] EDAC amd64: ECC disabled in the BIOS or no ECC capability, module will not load.
Either enable ECC checking or force module loading by setting 'ecc_enable_override'.
(Note that use of the override may cause unknown side effects.)
und dieser:
[ 819.828395] si2168 2-0064: downloading firmware from file 'dvb-demod-si2168-b40-01.fw'
[ 820.434187] si2168 2-0064: firmware version: B 4.0.11
[ 820.440484] si2157 3-0060: found a 'Silicon Labs Si2157-A30'
[ 820.489084] si2157 3-0060: firmware version: 3.0.5
lsmod hab ich auch mal eingegrenzt:
# lsmod | grep cx
cx23885 180224 10
altera_ci 20480 1 cx23885
tda18271 49152 1 cx23885
altera_stapl 32768 1 cx23885
m88ds3103 32768 2 cx23885
tveeprom 24576 1 cx23885
cx2341x 28672 1 cx23885
videobuf2_dvb 16384 1 cx23885
dvb_core 126976 4 m88ds3103,altera_ci,cx23885,videobuf2_dvb
v4l2_common 16384 2 cx2341x,cx23885
videobuf2_dma_sg 16384 1 cx23885
videobuf2_v4l2 24576 1 cx23885
videobuf2_core 40960 3 videobuf2_v4l2,cx23885,videobuf2_dvb
videodev 188416 5 cx2341x,videobuf2_core,v4l2_common,videobuf2_v4l2,cx23885
snd_pcm 98304 12 snd_hda_codec_hdmi,snd_hda_intel,snd_usb_audio,snd_hda_codec,cx23885,snd_cmipci,snd_hda_core
snd 81920 59 snd_hda_codec_generic,snd_seq,snd_seq_device,snd_hda_codec_hdmi,snd_hwdep,snd_hda_intel,snd_usb_audio,snd_usbmidi_lib,snd_hda_codec,snd_hda_codec_realtek,snd_opl3_lib,snd_timer,snd_mpu401_uart,cx23885,snd_cmipci,snd_pcm,snd_rawmidi
rc_core 36864 7 lirc_dev,ir_lirc_codec,ir_rc6_decoder,rc_rc6_mce,cx23885,serial_ir
und:
# lsmod | grep dvb
videobuf2_dvb 16384 1 cx23885
dvb_core 126976 4 m88ds3103,altera_ci,cx23885,videobuf2_dvb
videobuf2_core 40960 3 videobuf2_v4l2,cx23885,videobuf2_dvb
und:
lsmod | grep video
videobuf2_dvb 16384 1 cx23885
dvb_core 126976 4 m88ds3103,altera_ci,cx23885,videobuf2_dvb
videobuf2_dma_sg 16384 1 cx23885
videobuf2_memops 16384 1 videobuf2_dma_sg
videobuf2_v4l2 24576 1 cx23885
videobuf2_core 40960 3 videobuf2_v4l2,cx23885,videobuf2_dvb
videodev 188416 5 cx2341x,videobuf2_core,v4l2_common,videobuf2_v4l2,cx23885
media 40960 2 videodev,si2157
Ich benutze die Trinity Desktop Umgebung. Kradio heißt da TDERadio, ist aber das gleiche Programm. Ich konnte leider keine Tutorials zur Konfiguration finden (für beide nicht).