Hi,
auch die Firmware Snapscan1212U_2.bin funktioniert nicht, die hatte ich auch schon getestet. Die Datei hat auch die gleiche Größe wie snap1212u.bin.
Aktuell sieht /usr/share/sane/snapscan wie folgt aus:
[Mi Apr 26] > ls -lrt
insgesamt 128
-rwxrwxrwx 1 root root 32768 Mär 2 22:54 FIRMWARE.bin_
-rwxrwxrwx 1 root root 32768 Apr 24 09:27 snap1212u.bin
-rwxrwxrwx 1 root root 32768 Apr 26 10:30 SnapScan1212U_2.bin
lrwxrwxrwx 1 root root 44 Apr 26 10:31 FIRMWARE.bin -> /usr/share/sane/snapscan/SnapScan1212U_2.bin
-rwxr-xr-x 1 root root 32768 Apr 26 10:35 Snapscan1212U_2.bin
und die /etc/sane.d/snapscan.conf:
#------------------------------ General -----------------------------------
# Change to the fully qualified filename of your firmware file, if
# firmware upload is needed by the scanner
firmware /usr/share/sane/snapscan/Snapscan1212U_2.bin
#firmware /usr/share/sane/snapscan/snap1212u.bin
#firmware /usr/share/sane/snapscan/FIRMWARE.bin
# If not automatically found you may manually specify a device name.
# For USB scanners also specify bus=usb, e.g.
/dev/usb/scanner0 bus=usb
#
# For SCSI scanners specify the generic device, e.g. /dev/sg0 on Linux.
# /dev/sg0
#---------------------------------------------------------------------------
# No changes should be necessary below this line
#---------------------------------------------------------------------------
#-------------------------- SCSI scanners ----------------------------------
# These SCSI devices will be probed automatically
#scsi AGFA * Scanner
#scsi COLOR * Scanner
#scsi Color * Scanner
#scsi ACERPERI * Scanner
#--------------------------- USB scanners -----------------------------------
# These USB devices will be probed automatically
# (This will currently work only on Linux)
# Agfa 1212U
#found USB scanner (vendor=0x06bd [AGFA ], product=0x2061 [SNAPSCAN]) at libusb:003:004
usb 0x06bd 0x2061
ich bekomme halt mit xsane weiterhin den Fehler:
Fehler beim öffnen des Geräts 'snapsan:libusb:006:004'
Fehler während Geräte I/O:
und ich habe keine Ahnung, was nicht stimmt.
ich habe auch keine Gerätedatei unter /dev/usb/scannerxxx und mir ist es bis jetzt nicht gelungen eins zu erzeugen.
Wenn ich simple-scan benutzte erscheint in der konsole (auch als root):
** (simple-scan:9846): WARNING **: Couldn't connect to accessibility bus: Failed to connect to socket /tmp/dbus-R8j0f5mKpk: Verbindungsaufbau abgelehnt