Kernel zum x-tenmal installiert. Grafik spinnt und hier die Abfragen:
hopkins@hopkins-PC:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 802.11b/g/n ... ESSID:"WLAN-D4DF17"
Mode:Managed Frequency=2.437 GHz Access Point: 00:12:BF:D4:DF:3E
Bit Rate=130 Mb/s
Retry min limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=0/100 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
vboxnet0 no wireless extensions.
hopkins@hopkins-PC:~$ lsmod | egrep 'r8|87'
r8192s_usb 350626 0
shpchp 28774 0
hopkins@hopkins-PC:~$ sudo iwlist scan
[sudo] password for hopkins:
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wlan0 Scan completed :
Cell 01 - Address: 00:12:BF:D4:DF:3E
ESSID:"WLAN-D4DF17"
Protocol:IEEE802.11bg
Mode:Master
Channel:6
Encryption key:on
Bit Rates:54 Mb/s
Extra: Rates (Mb/s): 1 2 5.5 11 6 9 12 18 24 36 48 54
Quality=90/100 Signal level=-52 dBm Noise level=-115 dBm
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : CCMP
Pairwise Ciphers (1) : CCMP
Authentication Suites (1) : PSK
Extra: Last beacon: 16ms ago
vboxnet0 Interface doesn't support scanning.
hopkins@hopkins-PC:~$ dmesg | egrep 'r8|87'
[ 0.000000] RAMDISK: 2f876000 - 30033bdc
[ 0.000000] 887MB LOWMEM available.
[ 0.000000] #4 [002f876000 - 0030033bdc] RAMDISK ==> [002f876000 - 0030033bdc]
[ 0.000000] Kernel command line: BOOT_IMAGE=/boot/vmlinuz-2.6.32-02063229-generic root=UUID=666c1c08-e343-4c56-b587-affa7d5f582e ro quiet splash
[ 0.000000] lowmem : 0xc0000000 - 0xf77fe000 ( 887 MB)
[ 0.008487] Initializing cgroup subsys net_cls
[ 0.124872] ACPI: PCI Root Bridge [PCI0] (0000:00)
[ 0.125487] pci 0000:00:07.0: PME# supported from D2 D3hot D3cold
[ 0.151387] ACPI: WMI: Mapper loaded
[ 0.583887] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
[ 0.949487] ehci_hcd 0000:00:06.2: PCI INT C -> GSI 19 (level, low) -> IRQ 19
[ 0.960287] usb usb1: configuration #1 chosen from 1 choice
[ 0.960876] usb usb2: configuration #1 chosen from 1 choice
[ 1.221878] EISA: Probing bus 0 at eisa.0
[ 1.224872] tty tty49: hash matches
[ 1.908711] ata1.00: ATA-8: WDC WD1600AAJB-00J3A0, 01.03E01, max UDMA/133
[ 1.908720] ata1.00: 312581808 sectors, multi 16: LBA48
[ 1.908763] ata1.01: ATAPI: TOSHIBA DVD-ROM SD-M1612, 1806, max UDMA/33
[ 1.908796] ata1.00: limited to UDMA/33 due to 40-wire cable
[ 17.041241] r8192s_usb: module is from the staging directory, the quality is unknown, you have been warned.
[ 23.040722] rtl819xU:signature:8192, version:703e, size:30, imemsize:b408, sram size:87c8
[ 23.357876] vboxdrv: Successfully loaded version 3.2.8_OSE (interface 0x00140001).
[ 58.465787] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 76.648795] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 87.096049] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 87.096064] ===>ieee80211_associate_procedure_wq(), chan:6
[ 87.134525] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 87.134528]
[ 87.148941] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 87.148951] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 91.124087] ===>ieee80211_associate_procedure_wq(), chan:6
[ 107.708687] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 107.708707] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 107.772878] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 110.310876]
[ 116.824087] ===>ieee80211_associate_procedure_wq(), chan:6
[ 119.278747] =====>rtl8192SU_link_change 1
[ 125.938759] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 125.938783] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 130.871149] <=====rtl8192SU_link_change 2
[ 130.871164] ===>ieee80211_associate_procedure_wq(), chan:6
[ 141.208187] ===>ieee80211_associate_procedure_wq(), chan:6
[ 152.831087] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 169.343876] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 169.387934] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 169.387942]
[ 186.102787] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 187.528156] ===>ieee80211_associate_procedure_wq(), chan:6
[ 187.569205] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 187.569209]
[ 187.585868] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 187.585891] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 217.158752] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 217.158761]
[ 280.870503] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 280.870506]
[ 285.978745] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 285.978753]
[ 303.916087] ===>ieee80211_associate_procedure_wq(), chan:6
[ 343.642487] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 353.872619] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 353.872626] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 356.372087] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 359.029877] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 382.078777] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 382.078780]
[ 387.152097] Linking with WLAN-D4DF17,channel:6, qos:1, myHT:1, networkHT:0, mode:6
[ 429.353087] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 444.687387] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 444.687391]
[ 452.298387] rtl819xU:==>SetBWModeCallback8192SUsbWorkItem() Switch to 20MHz bandwidth
[ 470.187931] rtl819xU:<==SetBWModeCallback8192SUsbWorkItem()
[ 470.187951] =================>ieee80211_authentication_req():auth->algorithm is 0
hopkins@hopkins-PC:~$ uname -a
Linux hopkins-PC 2.6.32-02063229-generic #201105261657 SMP Thu May 26 18:03:16 UTC 2011 i686 GNU/Linux
hopkins@hopkins-PC:~$ cat /etc/modules
# /etc/modules: kernel modules to load at boot time.
#
# This file contains the names of kernel modules that should be loaded
# at boot time, one per line. Lines beginning with "#" are ignored.
lp
hopkins@hopkins-PC:~$