Naja..war nur so meine ahnname. mein problem könnte auch sein, das ich immer einen key (über der tastatur)drücken muss damit W-lan angeht.
(habe acerhk shon probiert.geht net)
lspci -v:
0000:02:00.0 Ethernet controller: Atheros Communications, Inc.: Unknown device 001c (rev 01)
Subsystem: Atheros Communications, Inc.: Unknown device 3065
Flags: fast devsel, IRQ 209
Memory at d0100000 (64-bit, non-prefetchable) [size=64K]
Capabilities: <available only to root>
iwconfig:
sebkinne@sebkinne:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
sit0 no wireless extensions.
ifconfig:
sebkinne@sebkinne:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:0A:E4:B7:CE:23
inet addr:192.168.2.103 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::20a:e4ff:feb7:ce23/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:177 errors:0 dropped:0 overruns:0 frame:0
TX packets:161 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:142836 (139.4 KiB) TX bytes:16358 (15.9 KiB)
Interrupt:50 Base address:0xa800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:7 errors:0 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:372 (372.0 b) TX bytes:372 (372.0 b)
lsmod | grep ath:
sebkinne@sebkinne:~$ lsmod | grep ath
new_ath_pci 98340 0
new_ath_rate_sample 14080 1 new_ath_pci
new_wlan 204892 2 new_ath_pci,new_ath_rate_sample
new_ath_hal 191312 2 new_ath_pci,new_ath_rate_sample