Hallo, hier ist Robert. Unse WG hat ein Router welcher kein WLan bietet und ein Hotline, welcher die WG mit dem Kabellosen Internetzugang versorgt. Dieses Gerät spinnt seit zwei Tagen und der Monats 1. ist schon ein paar Tage her, daher wollte ich als Kurzfristige Lösung mein Rechner als Router einrichten. Zu diesem Zweck laẞ ich den Artikel: http://wiki.ubuntuusers.de/wlan_router und entschied mich für die "Instant-AP Skript" Lösung.
Das Dort vorgestellte Skript habe ich auch an die richtige Stelle eingefügt und ich konnte das Skript zum laufen bringen. Das Ergebnis war das der Lan zugang nicht mehr ging.
Meine fragen: Was habe ich vergessen einzurichten? Wie vergebe ich dem neu erzeugten WLan Netz einen namen und ein Passwort?
die Hartware vorraussetzung erfüllt mein PC denke ich:
rob@rob-ThinkPad-Edge-E540:~$ iw list Wiphy phy0 max # scan SSIDs: 20 max scan IEs length: 425 bytes Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Device supports RSN-IBSS. Device supports AP-side u-APSD. Supported Ciphers: * CCMP (00-0f-ac:4) * TKIP (00-0f-ac:2) * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * CMAC (00-0f-ac:6) * WPI-SMS4 (00-14-72:1) Available Antennas: TX 0 RX 0 Supported interface modes: * IBSS * managed * AP * AP/VLAN * monitor * P2P-client * P2P-GO * P2P-device Band 1: Capabilities: 0x11e2 HT20/HT40 Static SM Power Save RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT TX/RX MCS rate indexes supported: 0-15 Bitrates (non-HT): * 1.0 Mbps * 2.0 Mbps (short preamble supported) * 5.5 Mbps (short preamble supported) * 11.0 Mbps (short preamble supported) * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 2412 MHz [1] (22.0 dBm) * 2417 MHz [2] (22.0 dBm) * 2422 MHz [3] (22.0 dBm) * 2427 MHz [4] (22.0 dBm) * 2432 MHz [5] (22.0 dBm) * 2437 MHz [6] (22.0 dBm) * 2442 MHz [7] (22.0 dBm) * 2447 MHz [8] (22.0 dBm) * 2452 MHz [9] (22.0 dBm) * 2457 MHz [10] (22.0 dBm) * 2462 MHz [11] (22.0 dBm) * 2467 MHz [12] (22.0 dBm) (no IR) * 2472 MHz [13] (22.0 dBm) (no IR) Band 2: Capabilities: 0x11e2 HT20/HT40 Static SM Power Save RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT TX/RX MCS rate indexes supported: 0-15 VHT Capabilities (0x038071a0): Max MPDU length: 3895 Supported Channel Width: neither 160 nor 80+80 short GI (80 MHz) TX STBC SU Beamformee VHT RX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT RX highest supported: 0 Mbps VHT TX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT TX highest supported: 0 Mbps Bitrates (non-HT): * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 5180 MHz [36] (22.0 dBm) (no IR) * 5200 MHz [40] (22.0 dBm) (no IR) * 5220 MHz [44] (22.0 dBm) (no IR) * 5240 MHz [48] (22.0 dBm) (no IR) * 5260 MHz [52] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5280 MHz [56] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5300 MHz [60] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5320 MHz [64] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5500 MHz [100] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5520 MHz [104] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5540 MHz [108] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5560 MHz [112] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5580 MHz [116] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5600 MHz [120] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5620 MHz [124] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5640 MHz [128] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5660 MHz [132] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5680 MHz [136] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5700 MHz [140] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5720 MHz [144] (22.0 dBm) (no IR, radar detection) DFS state: usable (for 902 sec) DFS CAC time: 0 ms * 5745 MHz [149] (22.0 dBm) (no IR) * 5765 MHz [153] (22.0 dBm) (no IR) * 5785 MHz [157] (22.0 dBm) (no IR) * 5805 MHz [161] (22.0 dBm) (no IR) * 5825 MHz [165] (22.0 dBm) (no IR) Supported commands: * new_interface * set_interface * new_key * start_ap * new_station * new_mpath * set_mesh_config * set_bss * authenticate * associate * deauthenticate * disassociate * join_ibss * join_mesh * remain_on_channel * set_tx_bitrate_mask * frame * frame_wait_cancel * set_wiphy_netns * set_channel * set_wds_peer * start_sched_scan * probe_client * set_noack_map * register_beacons * start_p2p_device * set_mcast_rate * channel_switch * Unknown command (104) * Unknown command (105) * connect * disconnect Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0x40 0xb0 0xc0 0xd0 * managed: 0x40 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * mesh point: 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-device: 0x40 0xd0 WoWLAN support: * wake up on disconnect * wake up on magic packet * wake up on pattern match, up to 20 patterns of 16-128 bytes, maximum packet offset 0 bytes * can do GTK rekeying * wake up on GTK rekey failure * wake up on EAP identity request * wake up on 4-way handshake * wake up on rfkill release * wake up on TCP connection software interface modes (can always be added): * AP/VLAN * monitor valid interface combinations: * #{ managed } <= 1, #{ AP, P2P-client, P2P-GO } <= 1, #{ P2P-device } <= 1, total <= 3, #channels <= 1 HT Capability overrides: * MCS: ff ff ff ff ff ff ff ff ff ff * maximum A-MSDU length * supported channel width * short GI for 40 MHz * max A-MPDU length exponent * min MPDU start spacing Device supports TX status socket option. Device supports HT-IBSS. Device supports SAE with AUTHENTICATE command Device supports low priority scan. Device supports scan flush. Device supports per-vif TX power setting P2P GO supports CT window setting P2P GO supports opportunistic powersave setting Driver supports a userspace MPM Device supports static SMPS Device supports dynamic SMPS rob@rob-ThinkPad-Edge-E540:~$ ^C rob@rob-ThinkPad-Edge-E540:~$