Moin, nach dem upgrade auf 18.10 wird der o.a. Scanner MustekBearPaw1200CU nicht mehr erkannt, sondern
~$ lsusb Bus 002 Device 002: ID 05d8:4002 Ultima Electronics Corp. Artec Ultima 2000 (GT6801 based)/Lifetec LT9385/ScanMagic 1200 UB Plus Scanner
~$ sudo sane-find-scanner found USB scanner (vendor=0x05d8, product=0x4002, chip=GT-6801) at libusb:002:002 # Your USB scanner was (probably) detected. It may or may not be supported by # SANE. Try scanimage -L and read the backend's manpage.
~$ export SANE_DEBUG_DLL=255 && scanimage -L [sanei_debug] Setting debug level of dll to 255. [dll] sane_init: SANE dll backend version 1.0.13 from sane-backends 1.0.27 [dll] sane_init/read_dlld: attempting to open directory `./dll.d' [dll] sane_init/read_dlld: attempting to open directory `/etc/sane.d/dll.d' [dll] sane_init/read_dlld: using config directory `/etc/sane.d/dll.d' [dll] sane_init/read_dlld: considering /etc/sane.d/dll.d/iscan [dll] sane_init/read_config: reading dll.d/iscan [dll] add_backend: adding backend `epkowa' [dll] sane_init/read_dlld: considering /etc/sane.d/dll.d/hplip [dll] sane_init/read_config: reading dll.d/hplip [dll] add_backend: adding backend `hpaio' [dll] sane_init/read_dlld: done. [dll] sane_init/read_config: reading dll.conf [dll] add_backend: adding backend `epkowa' [dll] add_backend: `epkowa' is already there [dll] sane_get_devices [dll] load: searching backend `epkowa' in `/usr/lib/x86_64-linux-gnu/sane' [dll] load: trying to load `/usr/lib/x86_64-linux-gnu/sane/libsane-epkowa.so.1' [dll] load: couldn't open `/usr/lib/x86_64-linux-gnu/sane/libsane-epkowa.so.1' (No such file or directory) [dll] load: couldn't find backend `epkowa' (No such file or directory) [dll] load: searching backend `hpaio' in `/usr/lib/x86_64-linux-gnu/sane' [dll] load: trying to load `/usr/lib/x86_64-linux-gnu/sane/libsane-hpaio.so.1' [dll] load: dlopen()ing `/usr/lib/x86_64-linux-gnu/sane/libsane-hpaio.so.1' [dll] init: initializing backend `hpaio' [dll] init: backend `hpaio' is version 1.0.0 [dll] sane_get_devices: found 0 devices No scanners were identified. If you were expecting something different, check that the scanner is plugged in, turned on and detected by the sane-find-scanner tool (if appropriate). Please read the documentation which came with this software (README, FAQ, manpages). [dll] sane_exit: exiting [dll] sane_exit: calling backend `hpaio's exit function [dll] sane_exit: finished
Was geht da schief? Grusskurt