nächster Anlauf entsprechend
[ubuntu:[wiki]WLAN/Konfiguration:[wiki\]WLAN/Konfiguration][/wiki]
/etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# This is a list of hotpluggable network interfaces.
# They will be activated automatically by the hotplug subsystem.
mapping hotplug
script grep
map wlan0
# The primary network interface
auto wlan0
# WLAN
iface wlan0 inet dhcp
pre-up /usr/sbin/wpa_supplicant -D wext -i wlan0 -c /etc/wpa_supplicant.conf -Bw
post-down killall -q wpa_supplicant
auto wlan0
/etc/wpa_supplicant.config
ctrl_interface=/var/run/wpa_supplicant
eapol_version=1
ap_scan=2
network={
ssid="FMFN20060201"
scan_ssid=1
proto=WPA
key_mgmt=WPA-PSK
pairwise=TKIP
group=TKIP CCMP
psk=a32f6789e134
}
und dann gibt es nach dem Hochfahren kein Funknetz. 😲
am Terminal-Prompt:
sudo ifconfig down
und
sudo ifconfig up
Dann wird der USB-Adapter angeblich aktiv, tut aber nicht, was er soll.
iwconfig zeigt:
wlan0 802.11b/g NIC ESSID:""
Mode:Managed Frequency=2.462 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s
Retry:off RTS thr=2432 B Fragment thr:off
Power Management:off
Link Quality=100/92 Signal level=10/154 Noise level=161/154
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
und dann die Krönung:
Administration | Netzwerk | Funknetz
möchte einen WEP-Eintrag (darauf könnte ich ja die Fritzbox umstellen),
der dann auch noch so in die Datei /interfaces gebügelt wird:
iface wlan0 inet dhcp
wireless-essid FMFN20060201
wireless-key 61676E6573
auto wlan0
So wird das einfach nichts... 🙄
Muss ich denn jeden PC erst an den Accesspoint schleppen und einstöpseln,
um ihn vorzukonfigurieren?
Und wie dann weiter? ❓
Herzliche Sonntagsgrüße ☺
egon